top of page
Resmed.jpg
AirCurve10.webp

DIAL

PDF.JPG

Device Operation

Below is an instructional video on how to use the AirCurve 10.

Below are the settings accessible at the My Options screen.

  1. TURN the dial to navigate between options. 

  2. PUSH the dial to select desired option.

RAMP TIME

The time period which the pressure increases from a lower pressure to the prescribed treatment pressure.       

  • Off

  • 5 - 45 min

Recommendation: Start at 20 min.  If it is ramping up too fast, try a higher ramp time such as 30 - 45 minutes.  If it is ramping up too slow, try a lower ramp time such as 5 - 10 minutes or turning ramp Off.

                                             

HUMIDITY LEVEL

The level the humidifier moistens the air you breathe during treatment.        

  • Off 

  • 1-8

Recommendation: Start at 4.  If your nose/mouth feels dry, increase the humidity level.  If you get too much condensation, try using ClimateLineAir heated tubing.

                          

ClimateLine Air .jpg

ClimateLineAir

Heated tubing

Available Product Downloads:

PDF.JPG

CLIMATE CTRL*

Controls temperature and humidity levels during therapy (*only available with ClimateLineAir connected).      

  • Auto - automatically adjusts to maintain a constant humidity level of 85%. 

  • Manual - you adjust Tube Temperature and Humidity Level separately.  

Recommendation: Start on Auto.   Humidifier output will adjust automatically to maintain a constant humidity level of 85%, which is considered comfortable for most people. 

                                             

TUBE TEMP*

The temperature inside the tube (*only available with ClimateLineAir connected).           

  • Auto

  • 60–86°F

  • Off

Recommendation: Start on Auto (with Climate Ctrl on Auto).  Tube temperature will be 81°F and Climate Control adjusts the humidifier output to maintain a constant humidity level of 85% while protecting against condensation.  

                                             

LEAK ALERT*

When enabled, the device will beep if there is too much air leak (*Must be enabled with Essentials Plus).    

  • Off

  • On       

SMARTSTART*

When enabled, unit will turn ON automatically when you breathe with mask on and turn OFF automatically when you remove it (*Must be enabled with Essentials Plus).    

  • Off

  • On       

MASK

The type of mask you are using with therapy.    

  • Pillows

  • Full Face 

  • Nasal                                    

Available Product Download:

PDF.JPG

TUBE*

Inner diameter of tubing used (*Must be enabled with Essentials Plus.  Disabled with ClimateLineAir connected).  

  • SlimLine: 15mm

  • Standard: 19mm

  • 3m                                

RUN MASK FIT

The unit will blow air to check for potential air leaks around your mask.

Recommendation: Run mask fit and adjust mask until you see a green face displayed.  If you are unable to get a good mask seal, talk to your provider about how to get a better fit.

RUN WARMUP

The humidifier will rise and hold at a warmer temperature (40°C/104°F) for a total of 30 minutes. 

Recommendation: Run warmup before you start therapy if the air is too cold or dry in the beginning of therapy. 

AIRPLANE MODE

This disables wireless connectivity and data transmission to AirView and MyAir applications.     

  • Off

  • On

Recommendation: Turn On if you need to disable wireless connectivity such as while using your unit on an airplane.

                                             

ABOUT*

Here you can view additional information about the unit such as Run Hours and ​internal modem information (*Must be enabled with Essentials Plus).

                                             

AirCurve 10 ASV

My Options

bottom of page